3Com CoreBuilder 9000, Getting Started Manual

Page: 63 / 78

Removing an ATM Interface Module from the 7-Slot Chassis 63
Figure 43 Tightening the Screws
Removing an ATM
Interface Module
from the 7-Slot
Chassis
You can remove an ATM Interface Module while the system is on.
To remove an ATM Interface Module:
1 Record the cabling scheme.
2 Disconnect all cables from the ATM Interface Module’s ports.
3 Loosen the two captive screws that secure the ATM Interface Module to
the chassis (Figure 44).
C ore Builder 9 000
®