58
C
HAPTER
4: I
NSTALLING
AND
R
EMOVING
THE
ATM I
NTERFACE
M
ODULE
Figure 37
Tightening the Screws
CAUTION:
To ensure adequate cooling air flow in the chassis, make sure
that blank faceplates cover all empty slots.
Removing an ATM
Interface Module
from the
16-Slot/8-Slot
Chassis
You can remove an ATM Interface Module while the system is on.
To remove an ATM Interface Module:
1
Record the cabling scheme.
2
Disconnect all cables from the ATM Interface Module’s ports.
3
Loosen the two captive screws that secure the ATM Interface Module to
the chassis (Figure 38).
Summary of Contents for CoreBuilder 9000
