3Com CoreBuilder 3500, Command Reference Manual

Page: 93 / 784

system serialPort terminalSpeed 93
system serialPort
✓
3500
9000
9400
3900
9300
terminalSpeed
Sets the terminal speed of your system serial port. The terminal speed is
set by changing the terminal connection port baud rates.
Valid Minimum Abbreviation
sy se t
Important Considerations
■
When you change the terminal port baud rate to something other
than 9600, the new setting becomes the new default, even after you
use the
system nvData reset
option.
■
You must adjust the baud setting of your terminal or terminal
emulator to match your system serial port’s baud rate before you can
reestablish communication using the terminal port.
■
You can use this command through the terminal serial port or through
a Telnet session. However, if you change the terminal speed while you
are in a Telnet session, you must reboot the system for the change to
take effect.
Options
Procedure (Local Connection)
1 To set the terminal speed for the serial port, from the top level of the
Administration Console, enter:
system serialPort terminalSpeed
Prompt Description Possible Values [Default]
Terminal
speed Signal speed for the terminal
connection
■
19200
■
9600
■
4800
■
2400
■
1200
9600
Confirmation Confirmation of terminal speed
change
■
y (yes)
■
n (no)
–