![background image](http://html1.mh-extra.com/html/3com/corebuilder-3500/corebuilder-3500_getting-started-manual_3105226040.webp)
40
C
HAPTER
4: C
ABLING
3
If you have not already done so, remove the SC
connector cover from the transceiver, as shown in
Figure 17.
Figure 17
Removing the SC Connector Cover
4
Attach the male duplex SC connector on the network
cable into the duplex SC port on the GBIC transceiver,
as shown in Figure 18.
■
If you are using an SX transceiver, the network
cable must support multimode transmission.
■
If you are using an LX transceiver, the network
cable must support single-mode transmission.
You can also connect an LX transceiver to multimode
fiber. See “Connecting the LX Transceiver to MMF” on
page 41 for details.
Figure 18
Cabling the GBIC Module
5
Attach the other end of the network fiber-optic cable
to the network device that you want to connect.
6
Repeat steps 1 through 5 for additional GBIC
modules.
SC connector cover
C
1000 BASE (GBIC)
3C35330
PWR
INS
ERR
L
E
T
INS
MODEM
TERMINAL
ETHERNET
10BT
1000BASE
GBIC module
GBIC
transceiver
Duplex
SC connector
Network cable
Summary of Contents for CoreBuilder 3500
