Manually Configuring IP Information
37
■
19,200 baud (bits per second)
■
8 data bits
■
no parity
■
1 stop bit
■
no hardware flow control
Refer to the documentation that accompanies the terminal emulation software for
more information.
3
Power up the switch. The Power on Self Test (POST) run automatically. The Switch
4500G takes approximately one minute to boot.
Setting Up the Switch with IP Information
You are now ready to manually set up the switch with IP information using the
command line interface.
1
The command line interface login sequence begins as soon as the switch detects a
connection to its console port.
If the login prompt does not begin immediately, press Enter a few times until it
starts.
2
At the login prompts, enter
admin
as your user name and press
Enter
. At the
password prompt press
Enter
again. If you have logged on correctly,
<4500G>
is
displayed as shown in Figure 23.
You automatically log on in User View.
Summary of Contents for 4500G Series
