3Com 3CRWE554G72T - OfficeConnect Wireless 11g Cable/DSL Router, User Manual, Page: 93 / 146

Advanced 93
Check the Enable RIP Mode check box to configure RIP on the Router.
The screen shown in Figure 72 displays
Figure 72 Enable RIP Mode screen
The screen displays RIP information for the LAN interface and WAN
interface. To set up or change the information for one or both interfaces:
1 Select one of Disable , Enable or Silent from the Operation Mode
drop-down list. If you select Enable, the Router transmits RIP update
information to other RIP enabled devices. If you select Silent, the Router
only receives RIP update messages.
2 Select either 1 (for RIPv1) or 2 (for RIPv2) from the Version drop-down list.
3Com recommends that you use RIPv1 if there is any RIP enabled device
on your network that does not support RIPv2. In all other case, select
RIPv2.
3 Select either Enable or Disable from the Poison Reverse drop-down list.
Poison Reverse is a feature that helps prevent data loops.
4 Select one of None , Password or MD5 from the Authentication Required
drop-down list. If you select Password, an unencrypted text password
must be set on all RIP-enabled devices. If you select MD5, the password
must be encrypted using the MD5 encryption algorithm.
5 If you selected Password or MD5 at step 4, enter a password at the
Authentication Code prompt.