Setting Up Command Line Interface Management
47
Figure 18
SNMP management over the network
Refer to
“Setting Up SNMP Management”
on
page 49
.
Setting Up
Command Line
Interface
Management
This section describes how you can set up command line interface
management using a local console port connection or over the network.
CLI Management via
the Console Port
To manage a Switch using the command line interface via the local
console port connection:
1
Ensure you have connected your workstation to the console port correctly
as described in
“Connecting to the Console Port”
on
page 38
.
2
Your Switch is now ready to continue being managed and/or configured
through the CLI via its console port.
CLI Management over
the Network
To manage a Switch using the command line interface over a network
using Telnet:
1
Ensure you have already set up the Switch with IP information as
described in
“Setting Up Overview”
on
page 32
.
2
Check that you have the IP protocol correctly installed on your
management workstation. You can check this by trying to browse the
World Wide Web. If you can browse, the IP protocol is installed.
3
Check you can communicate with the Switch by entering a
ping
command at the DOS prompt in the following format:
c:\ ping xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the Switch)
If you get an error message, check that your IP information has been
entered correctly and the Switch is powered up.
SNMP Network Management
Workstation
Switch
Connect over Network
using SNMP
DUA1730-0AAA04.book Page 47 Thursday, November 17, 2005 2:59 PM
Summary of Contents for 3C17304A
Page 6: ...DUA1730 0AAA04 book Page 6 Thursday November 17 2005 2 59 PM ...
Page 58: ...58 CHAPTER 4 PROBLEM SOLVING DUA1730 0AAA04 book Page 58 Thursday November 17 2005 2 59 PM ...
Page 70: ...70 APPENDIX B PIN OUTS DUA1730 0AAA04 book Page 70 Thursday November 17 2005 2 59 PM ...
Page 84: ...DUA1730 0AAA04 book Page 84 Thursday November 17 2005 2 59 PM ...
