3Com 3C17203 - SuperStack 3 Switch 4400, Implementation Manual

Page: 37 / 153

Aggregated Links 37
The Switch also has a mechanism to prevent the possible occurrence of
packet re-ordering when a link recovers too soon after a failure.
Aggregated Link —
Manual
Configuration
Example
The example shown in Figure 7 illustrates an 800 Mbps aggregated link
between two Switch units, (that is, each port is operating at 100 Mbps,
full duplex).
Figure 7 An 800 Mbps aggregated link between two Switch units
To manually set up this configuration:
1 Prepare ports 2, 4, 6 and 8 on the upper Switch for aggregated links. To
do this:
a Check that the ports have an identical configuration using your
preferred management interface.
b Add the ports 2, 4, 6 and 8 on the specified unit to the aggregated
link.
2 Prepare ports 2, 4, 6 and 8 on the lower Switch for aggregated links. To
do this:
a Check that the ports have an identical configuration using your
preferred management interface.
b Add the ports 2, 4, 6 and 8 on the specified unit to the aggregated
link.