3Com 3C16990, User Manual

Page: 100 / 180

7-4 C
HAPTER
7: S
PANNING
T
REE
P
ROTOCOL
(STP)
The Root Bridge generates BPDUs on all ports at a regular interval
known as the Hello Time. All other bridges in the network have a Root
Port. This is the port that costs the least in getting to the Root Bridge,
and it is used for receiving the BPDUs initiated by the Root Bridge.
Stabilization
After all bridges on the network have determined the configuration of
their ports, each bridge only forwards traffic between the Root Port
and the ports that are the Designated Bridge Ports for each network
segment to which they are attached. All other ports are
blocked , which
means that they are prevented from forwarding traffic.
Reconfiguration
In the event of a network failure (such as a segment going down) the
STP system reconfigures the network to adjust for the changes. If the
topology of the network changes, the Root Bridge sends out an SNMP
trap.
Spanning Tree
Domains
The Switch 9000 can be partitioned into multiple virtual bridges. Each
virtual bridge can run an independent spanning tree instance. Each
spanning tree instance is called a
Spanning Tree Domain (STPD). Each
STPD has its own Root Bridge and active path. Once the STPD is
created, one or more VLANs can be assigned to it.
A port can belong to only one STPD. If a port is a member of multiple
VLANs, then all those VLANs must belong to the same STPD.
The key points to remember when configuring VLANs and STP are the
following:
■
Each VLAN forms an independent broadcast domain.
■
STP blocks paths to create a loop-free environment.
■
When STP blocks a path, no data can be transmitted or received on
the blocked port.
SW9000.BK Page 4 Wednesday, April 1, 1998 11:00 AM