14
15
2VV.
Creating innovative solutions for you and your business since 1995.
ver.1 31-05-21
Label with the type of unit
•
The main power switch must be turned off before any
intervention on the unit!
•
The electrical connection must be done by a qualified
person (electrician). The electrical connection may
be done only by a person authorised for such tasks.
All the instructions herein and the local regulations
must be observed.
•
The wiring diagram on the product take precedence
over the diagrams included herein! Before connecti
-
ng, make sure that the terminal markings correspond
to the diagram. In case of doubt, do not connect the
unit and contact the supplier.
•
If the unit is connected to a control system other than
the original, contact that system’s supplier regarding
the connection of measuring sensors and control
components.
•
The unit must be connected to the mains with a tem-
perature resistant, rigid, insulated cable that com-
plies with the local regulations.
•
Any intervention or modifications to the internal elect
-
rical connection are forbidden and shall result on loss
of warranty.
•
The correct operation of the unit can be guaranteed
only with the use of original accessories.
•
Should it be necessary to install a sensor or control
device in the unit or its cover, consult with the manu
-
facturer or their representative.
6.4. CONNECTING THE WIRING AND
ELECTRICAL ACCESSORIES
ATTENTION!
Type of product
Serial number
U = Voltage
F
= Frequency
N = fan’s speed
Ph = number of phases
Av = Air flow
I
= Current
P =
power
M = hweight
IP = el. protection
Ver = version
6. INSTALLATION
6.4-1 Power cord
The terminal strip for the power cable is located in the
housing of the control device.
The minimum dimensions of
the safety grounding conductor
must conform with the applica
-
ble local regulations.
TECHNICAL INFORMATION
● The parameters of the wiring can be found on the label
located on housing of the control device.
Pe
L1
L2
L3
N
ATTENTION!
