Assembly Instructions Beta Prusa Minimal
30/05/13
Connection of the x motor to the electronic
Plug the cable into the right most motor connector on the electronics as is shown with the
highlighted cable in the image above. Make sure the red cable is on the right side.
Connection of the extruder
For connecting the Extruder, guide the cables from the extruder motor, the two red heater
wires and the thin thermistor wire in a big loop to the side and along the diagonal rod down to
the electronics.
Make sure the loop is big enough, so the extruder can fully move to both sides even in the
lowest setting.
Page 52 / 57
