Assembly Instructions Beta Prusa Minimal
30/05/13
Step 4.1
Needed parts for step 4.1
The following parts are needed for this step:
4x thick Spring
8x Washer M3
4x Nut M3 Nyloc
4x Screw M3 x 40 mm
1x Acrylic print bed
and the structures from the previous steps
Assembly step 4.1
Attach the acrylic print bed onto the Y carriage with four screws M3 x 40 mm and springs, cut
into four parts, and associated washers and nuts as shown in the pictures above The M3
Nyloc nut goes at the bottom. Make sure the print bed is exactly level, you can adjust the
height position of it with the Nyloc nuts.
Page 44 / 57
