Table of Programmable Parameters
3.2
72
Define when the IPsec tunnel should be established. If you do not want to use
UMTS due to a low data rate, use the WAN port only. The IPsec tunnel will then be
established only in case the main or back-up connection via WAN is active.
Exchange mode
Set one of the connection establishing modes mentioned above: Basic, Main or
Aggressive.
Identifier
Define the identifier for authorisation at the opponent’s. Options:
Address
,
FQDN
or
USER FQDN
. The PSK table setting is verified.
NAT Traversal
Enable the use of NAT: 2N® SpeedRoute always finds the whole route and use of
NATs.
Passive
Tick off to define that this party will not initiate connection.
Phase 1
Set phase 1 keying for negotiating details on IP connection, gateway, and similar.
Phase 2
Set encryption for data transmission.
Remote LAN address
Set the IP address of a remote network or an IP address from the range of the
remote network.
Remote LAN mask
Remote network mask.
Remote public gateway
Public IP address of the opposite gateway.
IPsec - Manual
Caution
Setting the IPsec function in this menu is rather difficult. Refer to the
dedicated IPsec HOW TO manual at
www.2n.cz
or on the enclosed CD for
more details.
IPsec – PSK
In this menu set the pre-shared security keys. The keys are included in the table
below according to the identifier settings in the VPN menu.
