2N SELEA iZero, User Manual

Page: 17 / 51

17 / 51 www.selea.com
2
1
4
3
5
6
8
7
5. Slightly lower the front enclosure.
6. Insert the male connector of the
RJ45 Ethernet network cable into
the appropriate female connector
located on the camera's electrical
board.
7. Return the front enclosure to the
closed position.
8. Tighten the two screws located on
the top of the camera.
We recommend the screws are screwed on the profile using an electric screwdriver so that there are no screws
screwed in with different forces from each other. In the upper part there is also a water seal and if the screws
were fixed with different forces, infiltrations might occur.
Inside the camera enclosure are some connections between the printed board and the camera body: do not
tamper with them or use any connections other than those described in these pages.
ELECTRONIC CARD INTERNAL CONNECTION
A
B
A
D1 D0 B A RX
RS232 RS485 WEIGAND
TX
B C D E F + -
12VDC
POWER
B
A
1
NO N0
E C A2
IN2 OUT1
OUT 2
K2
2 3 4 5 6 7 8
A1
IN1
K1
The image below shows the board with all the options
installed, allowing for the use of all the variants of
iZero
discussed in this manual.
A Multi-pole serial communication connector RS232/
RS485/OSDP/Wiegand and for power supply.
B Input and output connector.