2N TELEKOMUNIKACE a.s., www.2n.cz
40/66
Device Restart
Factory Reset
2N Helios IP Solo
®
is equipped with a RESET button. Press the button shortly (< 1 s) to
restart the system without changing configuration.
Follow the instructions below to
:
identify the current IP address
Press and hold the RESET button.
Wait until the red and green LEDs on the device come on simultaneously
(approx. 20 s).
Release the RESET button.
The device announces the current IP address via the loudspeaker connected
automatically.
Follow the instructions below to switch on the
mode (DHCP OFF):
Static IP address
Press and hold the REST button.
Wait until the red and green LEDs on the device come on simultaneously
(approx. 20 s).
Wait until the red LED goes off (approx. 5 s).
Release the RESET button.
The following network parameters will be set after restart:
IP address: 192.168.1.100
Nework mask: 255.255.255.0
Default gateway: 192.168.1.1
Follow the instructions below to switch on the
mode (DCHP ON):
Dynamic IP address
Summary of Contents for IP Solo
