Thank you for your purchase of the 2KRC Hyper EP. Fun Scale model Dago Red.
Please take a few moments to read this instruction manual before you beginning assembly and operation this
model.
This model are develop base on F5D model. So it has same size and design as a F5D model. But our design
and setup was for some one who like to have exciting and fun air race with his friend but not really plan to
going F5D competition. However we are strong recommend you consideration in serious before you operation
this model if you are
not a well experience RC. pilot.
Because even this model are not design for F5D
competition but it’s top speed are possibility up to
200km/h or even over
with the power unit that supply with
our combo kit.
Again this is not a Toy
..!
Serious injury, destruction of property, or even death may result from this misuse of
this product, 2KRC. is providing you, the buyer with a very high quality model aircraft component kit, from
which you, the buyer, will assemble a flying model. However it is beyond our control to monitor the finished
aircraft you produce. 2KRC. Will no way to accept or assume responsibility or liability for damages resulting
from the use of this user assembled product. This aircraft should be flown in accordance to the AMA safety
code. It is highly recommended that you join the Academy of Model Aeronautics in order to be properly
insured, and to operate your model at AMA sanctioned flying fields only. If you are not willing to accept all
liability for the use of this product, please return it to the place of purchase immediately.
2KRC. in no way warranties its aircraft against flutter. We have put these aircraft through the most grueling
flight tests imaginable and have not experienced any control surface flutter. Proper servo selection and linkage
set-up is absolutely essential. Inadequate servos or improper linkage set up may cause control surface flutter
and possibly complete destruction of your aircraft and cause Serious injury or destruction of property. If you
are not experienced in this type of linkage set-up or have questions regarding servo choices, please consult an
experienced pilot or contact us. It is your responsibility to ensure the airworthiness of your model.
ATTENTION!
Pre-flight checking:
Before every flying session check that all the model’s working systems function correctly, and be sure to carry
out a range check.
Be certain to keep to the recommended CG. Position and control surface travels. If adjustment are required,
carry them out the before operation the model.
Additional items needed to complete assembly.
A 2600KV. BL motor
are supply with this combo kit 1
st
or combo kit 2
nd
if you not choice not our combo kit.
Please choice a motor that size and specification same as our motor such Hacker B40S.
ESC: A 40 AMP
or 70 AMP. ESC. we have supply with our combo kit 2
nd
. If you choice please ensure the
ESC. you choice must a good quality products and size fit our model.
Spinner:
we have supply a good quality Alum. Spinner with combo kit 1
st
and 2
nd
, if you choice other
spinner, please choice a 38mm DIM.good quality Alum. Spinner and it must fit APC. 5.5X4.3 and 4.7X4.7 EP
prop.
Propeller
: we have recommended using only high quality EP. fix prop. such APC. 4.7X4.7 or same size in
Cam prop.
Servo
: we recommend using any high quality and high torque micro size servo such HS65MG. or similar.
Battery
. We recommend using 3S 11.1V 2000MA-2200MA discharge rate up to 20C or over. Lipo battery.
