2DI ThermaViewer, Manual

Page: 5 / 36

Quick Start
5
Your ThermaViewer can be installed and operating in minutes. Factory defaults are set to be used
with a refrigerator (21 o F. min., 41 o F. ref., 70 o F. max.). If you are installing a ThermaViewer on an
appliance other that a refrigerator, additional set up will be required (see page 27).
Important: If your ThermaViewer came equipped with the nine-volt battery pre-installed, you may
skip step one.
Once you have unpacked all ThermaViewer components, follow the simple steps below:
1. Install the nine volt battery.
Slide the battery cover on the top of the ThermaViewer forward.
Retrieve the battery wiring harness and attach the connector to the battery.
Insert the battery into the unit and reinstall the battery cover.
2. Attach the probe.
Insert the probe cable into port one on the right side of the unit (see illustration on page nine).
Attach the thermal probe to the other end of the cable.
3. Position the probe.
Attach probe to appliance wall. For best results, the probe should be positioned away from the
door toward the back of the unit approximately one-third of the way down from the ceiling.
Tape or permanently affix probe cable to the inside wall of the appliance. In larger units, it may
be desirable to install a second probe near the door to monitor temperature spikes due to door
usage.
4. Connect power supply
Attach the power cord and insert the plug into a 120 volt power source.