247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com
USER MANUAL,
ZEUS Pt
46
Click “Apply” to apply the new settings or “Continue” to review your new settings before
applying. Once you apply the new settings there, the previous settings will be lost. It is recommended to
click “Continue” so that you can verify all the new settings.
If click on the Apply button on uploading process, the confirm message display as below.
Click “Close” to close the DVR setup or “Continue” to make additional changes. You may need to
change the “DVR Server Name” at this point or adjust another specific setting relevant to the new
vehicle or application.
4.10.3
UPDATE FIRMWARE & MCU FIRMWARE
This feature will allow the user to update the firmware and MCU firmware of the ZEUS system
if needed. Firmware updates may contain new features and improvements, the update process should
only be done by a qualified technician. If the update process is not done correctly, your DVR may fail to
start properly and must be returned to your dealer for repair. Follow the following steps to successfully
update your ZEUS system firmware.
1.
Hard Drive Removal
a.
If DVR is running, turn the key lock to off position and wait until DVR powers off
b.
Open the door (Note: Leave it open during upgrading process)
c.
Insert Force Power on Cable into I/O CANBUS port then Remove hard drive
d.
Turn the key lock to ON position and wait until DVR boots up. DVR has finished
booting when both Ignition LED (green) and Power LED (green) are on solid.
2.
Connect to DVR and Save Current Configuration
a.
Connect cross-over network cable between DVR and your computer
b.
Verify your computer LAN IP address is 192.168.1.55
c.
Launch Internet Explorer
d.
Type http://192.168.1.100/ to access DVR setup
e.
You should now be at the login page
f.
Type “admin” as the User Name and “admin” as the password
g.
Go through each page and manually record on paper all the settings, it is very
important to record the correct DVR Server Name.
3.
Upgrading MCU (1 to 2 minutes)
a.
Go to the TOOLs Tab in the setup page
b.
Insert Force Power-on plug into the I/O CANBUS port on the rear of the system
c.
Browse for latest MCU file (example: ZEUSDVRV2-A0.09.hex)
d.
Update MCU then system shows popup:
