NE
12
Attaching the Sensor
To attach the Sensor to the household power line (see HOW THE PRODUCT WORKS) follow the steps
below:
WARNING: If in doubt about installing this product yourself, please consult a qualified electrician.
Plugging the Sensor into the Sender Box
Once the Current Sensor is attached to the household power line you may plug it into any of the three outlets
in the Sender Box by following the steps below:
Diagram
Instructions
1. Choose one of the three outlets.
2.. Plug in.
NOTE The signal wiring (approx. 1 volt, 1 milliamp) on the current sensor is double insulated suitable
for installation in a 240 volt domestic power supply meter box. When passing through an enclosure
opening, the wiring should be protected from sharp edges by fixed bushes.
It is possible to purchase further Sensors and use them simultaneously on multiple power lines (up to 3). This
may be useful in buildings with high rates of power consumption such as factories or ofÞces.
If more than one Sensor is used the total power consumption displayed will be a combined reading.
Locate the main household
active or ÔphaseÕ cable (see
How the product works).
Unclasp the housing,
following the letters in the
Diagram above.
Place Sensor around cable.
Re-clasp the housing.
Current Sensor with cable
attached.
OPE
A.
B.
A.
B.
C.
C.
N
2
4
CLO
3
SE
1
