Monitor Components
List
1.Arm Blood Pressure Meter
4.User manual
2.Cuff (Type BF applied part)
(about 22cm~42cm)
3. Storage bag
In order to get the best effect and protect your Arm Blood Pressure Meter,
please use the right battery and special power adaptor which complies
with U.S. safety standard.
•
.
Open the battery cover.
•
.
Install the batteries by matching
the correct polarity, as shown.
•
.
Replace the cover.
Installing and Replacing the Batteries
CAUTION
Remove batteries if the device is not likely to be used for some time.
The old batteries are harmful to the environment, do not dispose with other daily trash.
Remove the old batteries from the device and follow your local recycling guidelines.
CAUTION
Replace the batteries whenever the below happen
The shows
The display dims
The display does not light up
Do not dispose of batteries in fire. Batteries may explode or leak.
The Choice of Power Supply
1
.Battery powered mode:
6VDC 4×AAA batteries(Not Included)
2
.AC adaptor powered mode:
6V 1A
(Please only use the recommended AC
adaptor model).(Not Included)
Please unplug the adaptor to depart from
the using utility power.
(Please use 1byone
authorized cuff. The size
of the actual cuff please
refer to the label on the
attached cuff.)
Component list of
pressure measuring system
1 Cuff
2 Air pipe
3 PCBA
4 Pump
5 Valve
CUFF
AIR HOSE
AIR CONNECTOR PLUG
LCD DISPLAY
DC POWER SOCKET
MEM BUTTON
START/STOP BUTTON
SET BUTTON
BATTERY COMPARTMENT
AC adaptor
7
6
BEFORE YOU START
INTRODUCTION
