D. Re-pairing Function:
If a receiver starts ringing even when the push
button isn’t pressed, or a push button
interferes with other receivers, it may be
necessary to reset the current pairings and
pair again.
To reset the push button: Press the Paring
button on the receiver and hold for 5 seconds.
The LED light will come on and beep five
times then all pairing information for the push
button(s) will be deleted.
Next, unplug or remove the batteries from the
receiver and then reattach it to power after 30
seconds. The LED light will come on for 15
B. Selecting the ringtone:
There are 36 programmable ringtones to
choose from.
Press the Ringtone selector button to
change the ringtone.
Stop pressing this button when you reach the
desired ringtone.
C. Adjusting ringtone volume:
Press the Volume button until the desired
volume is set. There are 6 volume levels for
selection.
VOL
To change the notification mode (Sound only,
Flash only, and Sound+Flash), press the Mode
button on the side of the receiver.
When the Mode button is pressed, the receiver
will play a “beep” sound signifying Sound Only
mode; flash a LED signifying Flash Only mode;
play a “beep” sound and flash a LED at the
same time signifying Sound + Flash mode.
Press the Mode button until you reach your
preferred notification mode.
MODE
- 05 -
- 06 -
