6.4 **Before twisting the housing cap back on, make sure the Oring is seated at the end of the
membrane housing as shown in figures 8 and 9. This is very important to avoid leaking and
damage to the Oring.
6.5 Place the membrane housing cap back on and hand tighten it, then use the housing wrench to
tighten it another ¼½ of a turn. Do not over tighten.
6.6 **DO NOT reconnect the tubing to the fitting on the cap at this point (will be done in system
start up).
Step 7: Tubing Hook Up (model specific substeps are marked with * )
7.1 See figure Sample Installation
and figures of system top view, and note connection points AB,
CD, EF, and GH.
Page 11
www.123filter.com
| (678) 2617611 |
