100FIT 150B, Owner'S Manual

Page: 16 / 21

switch display in every 5 seconds.
9 PULSE
P-30~240
BPM
0-30~240
(±1)BPM
Yes Yes
a. If there is pulse signal input , it will displays the
initial value after 7.4s (count from the first PULSE
value.)
b. If there is no pulse for 6s, the value will return to
zero.
c. The calculate method ,pls refer to appendix 1.
d. If the pulse is above the preset value, the value in
the PULSE windows will flash in every second or
the PULSE OVER ALARM
10 SCAN NO NO NO NO
In SCAN mode, the
functions :STROKES-TIME-DIST- CAL- PULSE
will display in sequence and switch display in every
5s in the same windows.
11 STOP NO NO NO NO
If there is sensor signal input, the console can quick
start. If there is no sensor input in 6s, the console will
enter into the standby mode.
1. Power on and power off:
(1) . Power on:
Install 2 pcs 5 # batteries, then the console will power on , LCD will full display 2s (picture 1). After
that, it will enter into standby mode.( picture 2)
Picture 1
Picture 2
(2). Power off
：
A.
Without any signal being transmitted into the monitor for 4 minutes , it will enter into Sleeping mode.
B.
As signal input or press any key, the console would wake up.
3. Operation procedure (picture 3 - picture9
）
3.1 Power on
：