8
9
Anti-skating Force Adjustment
The anti-skating force must be adjusted corresponding to the tracking force as follows:
Tracking Force
Groove in the stub
④ ③ ② ①
5-10 mN
1st from bearing ring
10-15 mN
2nd from the bearing ring
15-20mN
3rd from the bearing ring
20mN and larger
4th from the bearing ring
1. Slip the loop of the anti-skating weight's thread over the
3rd
groove of the stick to
set the correct anti-skating force for the factory-fitted cartridge.
2. Feed the thread through the hook of the wire support.
Installing the Lid
Install the
Lid
carefully over the hinge prongs.
Setting Phono-Line Out Switch
This product has a built-in phono equalizer function. You can use the turntable, even
if you do not have a phono amplifier or connectable equipment with a built-in phono
amplifier.
Use the
Phono-Line Out Switch
to set the output, as shown below.
Connectable device being used
Position of Phono-Line Out Switch
Device with phono input
Phono
Device without phono input
Line
Connection to an Amplifier (Device with Phono input, PHONO mode)
This turntable uses a moving magnetic cartridge. Set the
PHONO & Line Out Switch
on PHONO mode. Connect the phono out cables to the phono input on your amplifier
of pre-amplifier (phono stage).
Line inputs such as CD, Tuner, Tape, or Video are
not suitable for phono inputs.
Make sure the amplification of the selected input
matches the type of cartridge being used. The factory installed cartridge is 47k ohms /
MM-input.
NOTE:
If your amplifier does not have an input suitable for phono cartridges, you
will need to purchase a separate phono amplifier for moving magnetic cartridges.
This separate phono amplifier will then connect between your turntable and your
amplifier.
Stereo System Connection (Device without phono input, LINE mode)
Set the
PHONO & Line Out Switch
to LINE mode. The RCA
PHONO & Line Out
Jacks
output analog line-level signals and can be connected directly with a pair of
active/powered speakers of the appropriate input of your stereo system.
The Red plug connects with the Right channel and the White plug connects
with the Left channel.
NOTE:
The RCA Jacks are not designed to be connected directly to passive/
unpowered speakers in LINE mode. If connected to the passive speakers, no sound
will come out.
Main Power Connection
Unpack the power adapter from the foam packing material and plug the small end
into the
DC power jack
located on the back of the turntable. Plug the power adapter
plug into an electrical outlet.