4
5
This turntable is supplied with a factory-fitted cartridge that’s already adjusted.
Note: Instructions provided in this manual for adjusting the cartridge are provided in
case the cartridge is replaced at a later date by a different model.
Installing the turntable
• Mount the turntable on a level surface.
• To avoid the effects of vibrations and acoustic pressure, do not mount the turntable
next to items such as speakers.
• The turntable may pick up radio static if placed next to a radio. Therefore, try to keep
the turntable away from transmission devices such as radios.
• If the turntable is near equipment (cell phone, etc.) that emits strong radio waves,
noise may occur.
Turntable Platter and Belt Setup
1. Turn the platter over and check the belt position.
Make sure that the drive belt is looped in the middle of the circle. The drive belt
located too high or too low in this circle may cause the drive belt to fall off or speed
to be unstable.
2. Set the platter on the spindle.
• Make sure that the platter is fully seated on the spindle.
Platter
Opening
Motor pulley
Spindle
3. Place the belt on the motor pulley.
• Align one of the platter openings with the motor pulley, and, while pulling both
ends of the red ribbon that comes attached to the belt, place the belt on the
motor pulley, as per the diagram. When doing this, be careful not to twist the belt.
Ribbon
Belt
Motor Pulley
Straight
Twisted
Wrong location
4. Remove the red ribbon from the belt.