6
7
Rotating the Platter
1. Using your hands, slowly rotate
the platter ten times in a clockwise
direction (Figure 1).
2. This step is for resetting the auto
mechanism, getting rid of any twists in
the belt and making sure the belt rides
smoothly along the drive rim on the
underside of the platter.
Figure 1
3. Place the slip mat on top of the platter.
Make sure the 1byone logo on the mat
is facing up (Figure 2).
Slip mat
Figure 2
Cartridge Tracking Force Adjustment
The supplied
Counterweight
is suitable for cartridges weighing between 3.0-6.0g.
1. Gently push and turn the Counterweight onto the
rear of the tonearm (with the dial facing towards the
front of the turntable).
Counterweight
Tracking Force Dial
2. Pull the protector straight forward to remove it.
Note:
Applying a downward force may cause the stylus
to come off the body. Only low volume is output if the
stylus has come off, or is about to come off, so refer to
“Replacing the stylus” to reattach the stylus correctly.
3. Remove the tie-wrap and unlock the tone arm.
4. Lower the tonearm lift and position the cartridge in the space between the tonearm
rest and platter.
5. Carefully rotate the
Counterweight
until the tonearm achieves a neutral, level
balance. The tonearm should return to this balanced position if it is moved up or
down. Perform this adjustment carefully.
Tonearm
Counterweight
Adjust so the tonearm is level
6. Once the tonearm is correctly balanced, return the tonearm to its rest. Without
moving the metal counterweight, gently rotate the
tracking force dial
to align
the
"0"
with the
black center line
. Check to make sure the tonearm is still neutrally
balanced.
Counterweight
Center Line
Tracking Force Dial
7. Finally, hold the
rear of the counterweight
and rotate it
counterclockwise
(as seen
from the front) to adjust the tracking force according to the cartridge manufacturer's
recommended
3.5g
.
Note:
Take care and do not touch the tracking force dial during adjusting the
tracking force.
1.5
1.25
1.0
1.75
0
0.2
5
1.2
5
1.0
1.75
0
1.5
Note:
Each mark on the dial represents 0.05g. The recommended tracking force for
the factory-installed cartridge is 3.5g±0.5g. It only goes up to 2g for one rotation of
the tracking force dial, meaning
you will need to make the second rotation and
stop at "1.5" to reach 3.5g.