ZyXEL Communications XGS2220 Series, Руководство пользователя

Страница: 47 / 655

Chapter 3 Hardware Panels
XGS2220 Series User’s Guide
47
2
Align the transceiver in front of the slot opening.
3
Make sure the latch is in the lock position (latch styles vary), then insert the transceiver into the slot with
the exposed section of PCB board facing down.
4
Press the transceiver firmly until it clicks into place.
5
The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning
properly.
6
Remove the dust plugs from the transceiver and cables (dust plug styles vary).
7
Identify the signal transmission direction of the fi ber optic cables and the transceiver. Insert the fi ber
optic cable into the transceiver.
Figure 18 Latch in the Lock Position
Figure 19 Transceiver Installation Example
Figure 20 Connecting the Fiber Optic Cables
3.1.2.2 Transceiver Removal
Use the following steps to remove an SFP transceiver.
1
Attach an ESD preventive wrist strap to your wrist and to a bare metal surface on the chassis.
2
Remove the fiber optic cables from the transceiver.
3
Pull out the latch and down to unlock the transceiver (latch styles vary).
Note: Make sure the transceiver’s latch is pushed all the way down, so the transceiver can be
pulled out successfully.
4
Pull the latch, or use your thumb and index fi nger to grasp the tabs on both sides of the transceiver, and
carefully slide it out of the slot.