ZyXEL Communications Prestige 642, Руководство пользователя

Страница: 57 / 73

Prestige 642 ADSL Modem
System Maintenance 6-11
6.6.2 Uploading System Configuration File
The configuration data, system-related data, the error log and the trace log are all stored in the configuration
file. Please be aware that uploading the configuration file replaces everything contained within.
Menu 24.7.2 shows you the instructions for uploading the configuration file. If you answer yes to the
prompt, the Prestige will go into debug mode. Follow the procedure below to upload the configuration file:
1. Enter “
atlc
” after the “
Enter Debug Mode
” message.
2. Wait for the “
Starting XMODEM upload
” message before activating Xmodem upload on
your terminal.
3. After successful firmware upload, enter “
atgo
” to restart the Prestige.
If you replace the current configuration file with the default configuration file, i.e., P642.rom, you will lose
all configurations that you had before and the speed of the console port will be reset to the default of 9600
bps with 8 data bit, no parity and 1 stop bit (8n1) . You will need to change your serial communications
software to the default before you can connect to the Prestige again. The password will be reset to the
default of 1234, also.
Figure 6-15 Menu 24.7.2 - System Maintenance - Upload System Configuration File
6.7 TFTP Transfer
In addition to the direct console port connection, the Prestige supports the up/downloading of the firmware
and the configuration file using TFTP (Trivial File Transfer Protocol) over LAN. Although TFTP should
work over WAN as well, it is not recommended.
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
system.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The system's console port speed (Menu 24.2.2) may change when
it is restarted; Please adjust your terminal's speed accordingly. The
password (menu 23) may change also.
3. When uploading the DEFAULT configuration file, the console port speed
will be reset to 9600 bps and the password to "1234".
Do You Which To Proceed:(Y/N)