ZyXEL Communications Prestige 642, Руководство пользователя

Страница: 52 / 73

Prestige 642 ADSL Modem
6-6 System Maintenance
Table 6-3 System Maintenance Menu Diagnostic
Field Description
Reset ADSL This command re-initializes the ADSL link to the telephone company.
Ping Host This diagnostic test pings the host, which determines the functionality of the
TCP/IP protocol on both systems and the links in between.
Reboot System This option reboots the Prestige.
Command Mode
This option allows you to enter the command mode. This mode allows you to
diagnose and test your Prestige using a specified set of commands.
6.3 Filename conventions
The configuration file (often called the romfile or romfile-0) contains the factory default settings in the
menus such as password, DHCP Setup, TCP/IP Setup etc. It arrives from ZyXEL with a name of
P642.ROM or similar. Once you have customized the Prestige's setting, they can be saved back to
PC/workstation under a filename of your choosing. Choose something meaningful, e.g. “MyP642.cfg”.
The ZyNOS firmware file (sometimes referred to as the ras file) is the file that contains the ZyXEL
Network Operating System firmware and usually is the router model name with a *.bin extension, e.g.,
P642.bin.
With serial (xmodem) transfer, the filenames on the PC are your choice. With many ftp and tftp clients,
they are as well as seen next.
ftp>
put P642.bin ras
This is a sample ftp session showing the transfer of the PC file "P642.bin" to the Prestige.
ftp>
get rom-0 MyP642.cfg
This is a sample ftp session saving the current configuration to the PC file MyP642.cfg.
If your [t]ftp client does not allow you have a destination filename different than the source, you will need
to rename them as the Prestige only recognizes "rom-0" and "ras". Be sure you keep unaltered copies of
both files for later use.
The following table is a summary. Please note that the internal filename refers to the filename on the
Prestige and the external filename refers to the filename not on the Prestige, i.e., on your workstation, local
network or ftp site and so the name (but not the extension) will vary. The AT command is the command
you enter after you press “Y” when prompted in the SMT menu to go into debug mode. After uploading
new firmware see the
ZyNOS F/W Version
field in Menu 24.2.1 ( Figure 6-4 ) to check you have
uploaded the correct firmware.