6
6
6.
Use the power adaptor provided with your P-2812HNU(L)-Fx Series
to connect an appropriate power source to this socket.
7.
Push the
POWER
button to the
ON
position.
Look at the LEDs (lights) on the front panel of the P-2812HNU(L)-Fx
Series:
• The
POWER
light blinks during start-up and stays on once the P-
2812HNU(L)-Fx Series is ready.
• The
ETHERNET
light turns on if the corresponding
ETHERNET
port
is properly connected and it blinks when there is traffic. If you do not
connect a computer correctly to any of these ports, the
ETHERNET
lights will not turn on.
• The
WLAN/WPS
light stays on and green when the wireless LAN is
ready.The light will not turn on if the wireless connection is not
activated. It is blue when WPS configured.
• The
DSL
light will stay on if a physical
DSL
connection exists.
• The
WAN
light stays on if a physical Ethernet connection to the WAN
exists. It blinks when transmitting data.
• The
INTERNET
light is green when Internet access is available. It
blinks when transmitting data.
• The
PHONE
lights stay on when your SIP account is registered and
they blink if the receiver is off the hook.
• The
USB
light(s) turn on when there is a USB device (printer or
memory stick) or a 3G adapter connected to the P-2812HNU(L)-Fx
Series and blinks when transmitting data.
If the
POWER
light does not turn on during start up, try turning the P-2812HNU(L)-
Fx Series off, check the connections, wait a few seconds and then turn it back on. If
the problem persists, you may have a hardware problem and you need to contact
your vendor.
