ZyXEL Communications P-2302HWL-P1, Руководство по выпуску прошивки

Страница: 13 / 36

ZyXEL Confidential
360AJB0C1.rtf 13/36
ctrleint ADSL CTRLE response command
defbitmap ADSL defect bitmap status
dyinggasp Send ADSL dyinggasp
fwav Test the ADSL F/W available ping
fwdl Download modem code, but must reset first
linedata
near Show ADSL near end noise margin
far Show ADSL far end noise margin
open Open ADSL line
opencmd Open ADSL line with specific standard
opmode Show the operational mode
perfdata Show performance information,CRC,FEC, error
seconds..
rdata [start] [length] Read DSP CTRLE registers 512 bytes
reset Reset ADSL modem, and must reload the modem
code again
selftest
long ADSL long loop test
short ADSL short loop test
status ADSL status (ex: up, down or wait for init)
version ADSL version information
vendorid ADSL vendor information
utopia Show ADSL utopia information
cellcnt Show ADSL cell counter
display
shutdown Show the counter of rate adaptive mechanism
happening
rateup Show real status that rate adaptive mechanism
happened
rateadap [on|off] Turn on/off rate adaptive mechanism
dumpcondition [on|off] Turn on/off online debug information of rate
adaptive mechanism
sampletime [mins] Tune the sample time of rate adaptive mechanism
noisegt [dB] if noise margin is 3db greater than before, and
rate is worse than before, then system will do “L1
shutdown RA3”, default is 3db
noisemargin [dB] if noise margin is greater than this value, and rate
is worse than before, then system will do “L1
shutdown RA3”, default is 8db
persisttime [time] when the adaptive condition is matched system
will continue to monitor the time period
ersisttime_ before doing 1 shutdown RA3_,
default is 30 seconds
timeinterval [mins] when “L1 shutdown RA3” is done twice, and still
can’t reach the max rate which system recorded,
it will delay a time period that the period base
time is”timeinterval” before starting again. The
time-based default is 2 hrs
defectcheck [on|off] Turn on/off detect table checking, default is on
txgain [value] Set the CTRLE register (0xc3), the value is from
0xfa to 0x06
targetnoise [value] Set the CTRLE register (0xc4), the value is from
0xfa to 0x06
maxtonelimit [value] Set the CTRLE register (0xc5), the value is from