ZyXEL Communications CellPipe 7130 RG, Руководство пользователя

Страница: 144 / 404

Chapter 7 Wireless LAN
CellPipe 7130 RG User’s Guide
144
Bandwidth Select whether the CellPipe 7130 RG uses a wireless channel width of
20MHz or 40MHz.
A standard 20MHz channel offers transfer speeds of up to 150Mbps
whereas a 40MHz channel uses two standard channels and offers speeds
of up to 300 Mbps.
40MHz (channel bonding or dual channel) bonds two adjacent radio
channels to increase throughput. The wireless clients must also support 40
MHz. It is often better to use the 20 MHz setting in a location where the
environment hinders the wireless signal.
Select 20MHz if you want to lessen radio interference with other wireless
devices in your neighborhood or the wireless clients do not support
channel bonding.
This field is available only when you set the 802.11 Mode to 802.11n
Only or 802.11b/g/n Mixed in the Advanced Setup screen.
Control
Sideband This is available for some regions when you select a specific channel and
set the Bandwidth field to 40MHz. Set whether the control channel (set
in the Channel field) should be in the Lower or Upper range of channel
bands.
This field is available only when you set the 802.11 Mode to 802.11n
Only or 802.11b/g/n Mixed in the Advanced Setup screen.
Network
Name (SSID) The SSID (Service Set IDentity) identifies the service set with which a
wireless device is associated. Wireless devices associating to the access
point (AP) must have the same SSID. Enter a descriptive name (up to 32
printable 7-bit ASCII characters) for the wireless LAN.
Note: If you are configuring the CellPipe 7130 RG from a computer
connected to the wireless LAN and you change the CellPipe
7130 RG’s SSID or wireless security settings, you will lose your
wireless connection when you press
Apply to confirm. You
must then change the wireless settings of your computer to
match the CellPipe 7130 RG’s new settings.
Hide Network
Name (SSID) Select this check box to hide the SSID in the outgoing beacon frame so a
station cannot obtain the SSID through scanning using a site survey tool.
Enable
Wireless
Multicast
Forwarding
(WMF) Select this check box to allow the CellPipe 7130 RG to convert wireless
multicast traffic into wireless unicast traffic.
BSSID This shows the MAC address of the wireless interface on the CellPipe 7130
RG when wireless LAN is enabled.
Security
Mode See the following sections for more details about this field.
MAC Filter Click this button to go to the MAC Filter screen to configure whether the
wireless devices with the MAC addresses listed are allowed or denied to
access the CellPipe 7130 RG using this SSID.
Table 29 Network > Wireless LAN > General
LABEL DESCRIPTION