ZyXEL Communications ALC1224, Руководство пользователя

Страница: 119 / 136

ALC1224 User’s Guide
ADSL Port Commands 11-15
11.5.3 MAC Count Disable Command
Syntax:
lcman port macccount disable <slot-port>
where
<slot-port> =
The number of the slot where the ALC1224 is located and the number of an
ADSL port.
This command disables the MAC filtering feature on a specific port or on all ports if no port is specified.
The following example turns off the MAC count filter on ADSL port 1 on the line card in slot 3.
ras> lcman port maccount disable 3-1
11.5.4 MAC Count Set Command
Syntax:
lcman port maccount set <slot-port> <count>
where
<slot-port> =
The number of the slot where the ALC1224 is located and the number of an
ADSL port.
<count> =
Set the limit for how many MAC addresses that a port may dynamically learn.
For example, if you are configuring port 2 and you set this field to "5", then
only five devices with dynamically learned MAC addresses may access port 2
at any one time. A sixth device would have to wait until one of the five learned
MAC addresses ages out.
The valid range is from “1” to “1024”.
This command sets the limit for how many MAC addresses a specified port may dynamically learn.
The following example sets the MAC count filter to allow up to 50 MAC addresses to be dynamically learned on
ADSL port 1 on the line card in slot 3.
ras> lcman port maccount set 3-1 50
11.6 Port Isolate Command
Syntax:
ras> lcman port isolate [<enable|disable>]
This command turns the Integrated Ethernet Switch isolation feature on or off. Enable the Integrated Ethernet
Switch isolation to block communications between subscriber ports. When you enable the Integrated Ethernet
Switch isolation feature, you do not need to configure the VLAN to isolate subscribers.