Zakład Wytwórczy Aparatów Elektrycznych Sp. z o.o.
12
Regulation process should be performed in following way:
a) Initially coupling tie rods should be installed in such a way that one pole would not be connected (tie rod
ending hang on a line below coupling lever);
b) Coupling tie rod should be extended or shortened in such a way that current path in driving pole would
be achieve require limit positions. If tie rod length change forecloses achievement of the limit positions
driving lever position should be changed on driving pole. The next figure presents the behavior of the
disconnector’s poles when changing the position of the dive lever while maintaining the same length of
tie rod. After changing the position of the lever it is necessary to correct the of the tie rod and check limit
positions of the current path.
c) After finishing one pole coupling regulation it is permitted to tighten up tie rod to the last pole and repeat
steps from subpoint b.
Regulation lever
– left position.
Regulation lever
– right position.
Regulation lever
– neutral position.
