4.5
Rear panel description
Figure 4-6 shows the rear panel of the Network Video recorders. Table 4-2 shows the
interface of rear panel.
Figure 4-6
Rear panel
Table 4-2
Real panel description
No.
Name
Description
1
POE port
Poe power supply port
2
FANS
When power on Fans ON
3
Power Input
DC12V,5A power input (Supplied)
4
Switch
For switching HDMI or VGA output ,default is
VGA output
5
Network Interface
Headphones, stereo audio device. RJ45 100Mbps
network interface. (WAN Connection)
6
DVI Output
Video output interface, VGA or HDMI output. VGA
uses supplied DVI – VGA converter interface.
7
Audio output
Audio output.
9
No.
Name
Description
8
RST button
Restores the factory default settings. 5 second holds
9
GND connect
GND connect
10
DC48V Power
interface
DC48V.1.04A power input
4.6
First boot
z
Make sure that the right of access to power NVR.
z
Ensure correct display HDMI or VGA interface connection is set from switch
If the front panel of the power indicator lamp does not flash please plug in the power
cable .Enable the power switch, NVR start running. If the front panel power indicator
lamp flashing Red light, please put the switch at front panel to start device. Note: If
want to use POE power supply, please plug in the DC48V power adapter.
After the device starts, the power light is solid red device starts after the self-test, and
the test results are displayed on the screen. Show in Figure 4-7. Entire boot process
takes about two minutes.
Figure 4-7
Device power on
10
