9. Calibration and Alarms
●
Calibration
When in Balance Mode, if the Gyroshoe moves forward or backward on its own on flat ground, it needs to be calibrated.
If the problem persists, please contact after-sales service.
To Calibrate the Gyroshoe:
Cleaning and Storing Your Gyroshoes
Use a soft, wet cloth to wipe the mainframe clean. Stubborn dirt can be scrubbed with a toothbrush and toothpaste,
then cleaned with a soft, wet cloth.
Place the Gyroshoe upside down on flat ground
and power it off, press the power button for 5
seconds till you hear it beep 3 times. This will
complete the calibration.
Once powered on, the Gyroshoe must stay on the ground. To avoid injury do not touch the wheel
with any part of your body.
a. Overheating
Riding for an extended period of time could increase the internal
temperature of your Gyroshoes in excess of 122°F(50º C). If this happens,
the glow lights will flash red, an alarm will sound and your Gyroshoes will
not be able to charge. Simply step off the Gyroshoes, power them off,
and give them time to cool back down to a normal operating
temperature .
To avoid injury, do not touch or ride the Gyroshoes while there
is an alarm and the glow lights are flashing red.
10. Maintenance
●
Alarms
b. Other Alarms
For any other alarms, try restarting
your Gyroshoes. If the problem
persists, please contact after-sales
service.
13
12
NOTE
Do not wash your Gyroshoes with alcohol, gasoline, acetone, or other corrosive/volatile solvents. These substances
may damage the appearance and internal structure of your Gyroshoes. Do not wash your Gyroshoes with a power
washer or high pressure hose.
Make sure the Gyroshoes are powered OFF, the charging cable is unplugged, and the rubber cap on the charge port is
tightly sealed before cleaning; otherwise you may expose yourself to electric shock or damage the electronic
components.
Store your Gyroshoes in a cool, dry place. Do not store them outdoors for extended periods of time. Exposure to
sunlight and temperature extremes (both hot and cold) will accelerate the aging process of the plastic components
and may reduce battery life.
Battery Pack Maintenance
Do not store or charge the battery at temperatures outside the stated limits (see Specifications). Do not expose the
battery to fire. Do not discard or destroy the battery. Refer to your local laws and regulations regarding battery
recycling and/or disposal.
A well maintained battery can perform well even after many miles of riding. Charge the battery after each ride and
avoid draining the battery completely. When used at room temperature (70°F [22°C]) the battery range and
performance is at its best; whereas using it at temperatures below 32°F (0°C) can decrease range and performance.
Typically, at 14°F(-10°C) range can be half that of the same battery at 70°F (22°C). Battery range will recover when
temperature rises.
NOTE
Typically, a fully charged battery should retain charge for 120-180 days. Remember to charge the battery after
eachuse. Completely draining the battery may cause permanent damage to the battery. Electronics inside the battery
recordthe charge-discharge condition of the battery; damage caused by over-discharge or under-discharge will not be
covered by the Limited Warranty.
Do not attempt to disassemble the battery. Risk of fire. No user serviceable parts.
Do not ride when the ambient temperature is outside the machine operation temperature(see Specifications) because
low/high temperature will limit the maximum power/torque. Doing so could cause personal injury or property
damage due to slips or falls.
WARNING
WARNING
WARNING
,
When in Balance Mode, if the ZUUM Shoes move forward or backward on its own on flat ground,
it needs to be calibrated. If the problem persists, please contact
after-sales service.
To Calibrate the ZUUM Shoes:
Place the ZUUM Shoe upside down on flat ground
and power it off, press the button for 5 seconds
until you hear it beep 3 times. This will complete
calibration.
Once powered on, the ZUUM Shoe must stay on the ground. To avoid injury do not touch the
wheel with any part of your body.
Riding for an extended period of time could increase the internal
temperature of your ZUUM Shoes in excess of 122°F(50°C). If
this happens, the glow lights will flash red, an alarm will sound
and your ZUUM Shoes will not be able to charge. Simply step off
the ZUUM Shoes, power them off, and give them time to cool back
down to a normal operating temperature.
To avoid injury, do not touch or ride the ZUUM Shoes while there
is an alarm and the glow lights are flashing red.
For any other alarms, try
restarting your ZUUM Shoes.
If the problem persists, please
contact after-sales service.
Cleaning and Storing Your ZUUM Shoes
Do not wash your ZUUM Shoes with alcohol, gasoline, acetone, or other corrosive/volatile solvents.
These substances may damage the appearance and internal structure of your ZUUM Shoes. Do not
wash your ZUUM Shoes with a power washer or high pressure hose.
Make sure the ZUUM Shoes are powered OFF, the charging cable is unplugged, and the rubber cap
on the charge port is tightly seals before cleaning; otherwise you may expose yourself to electric
shock or damage the electronic components.
Store your ZUUM Shoes in a cool, dry place. Do not store them outdoors for extended periods of time.
Exposure to sunlight and temperature extremes (both hot and cold) will accelerate the aging process
of the plastic components and may reduce battery life.
