9
Command Example:
>
To route input 4 to output 1, send the following string: TX01
△
04Enter
>
To route input 2 to all output, send the following string: RX02
△
ffEnter
>
To route input 2 to output 1,2,4, send the following string: RX02
△
01,02,04Enter
>
To put in standby the matrix, send the following string: POWER
△
00Enter
Commands are case insensitive.
The Matrix will reply
OK
once string is correct,
NG
in case of incorrect string
7. Web Control Function:
Initial IP Configuration
1.
Setup MATRIX IP Address based on 4.3 ETHERNET section.
NOTE: If you set by DHCP go back to ETHERNET/IP address to confirm IP to enter into browser.
2.
Input IP Address on a web page, so you can link to the Web UI of the MATRIX host.
3.
Web UI Operation below:
Switch Settings:
POWER
Control MATRIX power on and standby
OUTPUT
Display output 1~10, you can change the display name by the Aliases page
INPUT
Display input 1~10, this field is a drop down menu, you can change the display name by
the Aliases page.
RELOAD
Get MATRIX host message.
ADVANCED
Enter into the “Advanced” page.
APPLY
Complete the setting
