3
LTE Cellular Connection
If your gateway is configured for LTE cellular capability (Model
ZGW-LORA-W1-LTE), it will have shipped to you with an active SIM
card already installed.
Note:
The ZGW-LORA-W1-LTE works only on the AT&T network, and
connects automatically once the gateway is powered and in range of
the AT&T network signal.
Cabling, Powering and Connecting
Your Device
1. Connect one end of the RJ45 Ethernet cable (supplied) to the
gateway’s Ethernet port and plug the cable’s other end into the
nearest wall port of the building’s Ethernet network.
2. Connect the power supply to the power jack.
3. Wait for status LED to go from ON to double flash every second, the
LoRa LED to turn ON solid, and the cell LED (if LTE enabled) to flash
once every 3 seconds. Should take around 1-2 minutes depending on
location. Your gateway is now ready to transmit data from your Zurn
connected product.
ITEM
DESCRIPTION
LEDS
Status
Blinks when operating system is fully loaded.
LoRa
LoRa service active LED displays ON when actively
connected and OFF when not connected.
Cell
Cellular models only.
Lights when there is power to the radio.
Blinks when the SIM is registered with the carrier.
WiFi
Reserved for future use. Always OFF.
Ethernet Link
(Green)
Left LED on the Ethernet connector. Blinks when data is
sent or received on the Ethernet link. Steady light when
there is a valid Ethernet connection.
Ethernet Speed
(Orange)
Right LED on the Ethernet connector.
Lit when the Ethernet is linked at 100 Mbps.
If not lit, the Ethernet is linked at 10 Mbps.
