FV617 Rev. - 4/17/2017
Page 6
Care and Cleaning Instructions:
•
Do not use any abrasive or chemical cleaners to clean the soap dispensers.
•
If abrasives or chemicals are used it can lead to dulling of luster, attacking of chrome plating or decorative finishes.
•
ONLY use mildly warm soapy water, and then wipe the device dry with a clean/soft towel or cloth.
•
Upon cleaning other areas of the restroom be sure the sensor lenses are protected from other cleaning chemicals/solvents to
prevent potential damages to the sensor and/or electronics.
•
It is recommended to flush the system with warm water every 3 to 6 months.
- With a minimal amount of soap in the soap bottle, fill the soap bottle with warm water.
- Screw the soap bottle back onto the control box and press the green system prime button. Hold down the button until all of
the water has been flush through the system.
- Refill the soap bottle with soap and press the system prime button. Hold down the button until any residual water ins
pushed through the pump and soap is being dispensed. The dispenser is now ready to use.
