FV723 Rev. B 7/29/2020
Page 5
6. Ensure that sink is clear of tools/debris and is in normal
operating condition, and remove protective film from sensor lens
has been removed.
7. Turn on water supply(ies).
*** Water supply must be turned on in order for sensor to perform
wet calibration step ***
8. Connect sensor cable from spout to monitor.
Do not engage the sensor after the connection is made. The
sensor will perform automatic calibration, which could flow
water for up to 60 seconds. Once the flow of water has stopped,
the faucet is calibrated and can be used normally.
• Do not use any abrasive or chemical cleaners to clean the faucets.
•
If abrasives or chemicals are used it can lead to dulling of luster, attacking of chrome plating or decorative finishes.
• ONLY use mildly warm soapy water, and then wipe the device dry with a clean/soft towel or cloth.
•
Upon cleaning other areas of the restroom be sure the sensor lenses are protected from other cleaning chemicals/solvents to prevent
potential damages to the sensor and/or electronics.
Care and Cleaning Instructions
