ZURN AquaSense Z6936, Инструкция по установке, эксплуатации, обслуживанию и каталог запасных частей

Страница: 7 / 8

FV764 Rev. A 01/25/21
Page 5
Whilst modern plating techniques are used in manufacture of this product, the surface will be affected if cleaned incorrectly.
Surfaces should be maintained using a lean damp cloth, no abrasive agents or materials should be used or come into contact with the
surface finish, or this will invalidate your warranty
For further assistance with troubleshooting visit http://www.zurn.com
Problem Possible Cause Corrective Action
No water out The battery is exhausted
(DC item)
Change the battery
Water supply cut off Check water supply
Dirt in the filter Clean the filter
Water pressure is too low Raise the pressure
Water will not turn off Dirt on the sensor window Clear the dirt
Too little water flow Water supply is turned too small Adjust water supply
The filter is too dirty Clean the filter
Water pressure is too low Raise the pressure
Too much water flow Water supply is turned too high Adjust supply
Water pressure is too high Adjust pressure
Short cycles of battery Incorrect batteries Change to 4 AA alkaline battery
The indicator light
is not on
The light is broken Change the light or circuitry board
The circuitry board is wet or
signal line is wet
Dry out
The battery is exhausted Change the battery
Poor connection of battery Check the battery connection
Trouble Shooting: Faucet
Care & Maintenance