ZupAir ZULU, Руководство пользователя

Страница: 4 / 9

4
Assembly
1. Sand the join area to remove mold release agent, then bond the fin to the
fuselage with Foam Tac or other foam glue.
2. The servo pockets were sized for
ES09MD servos, and measure 23 x 12 x
24.5mm. If your servos are larger, use
a hobby knife to increase the pocket
size. For smaller servos, fill the gaps
with spare foam, balsa wood, etc.
3. Hook up your servos to your receiver and set the trims on your transmitter to
neutral. Attach the servo arm so that it points away from the wing surface at
roughly 90°, as shown below.
4. Connect the elevon pushrod near the middle of the servo arm, and the
drooperon pushrod one hole above (more travel). Attach the other end of the
linkages to the control horns, using the outer-most holes.
Front
elevon
pushrod
drooperon
pushrod