•
In the case that an orange get trapped between the Front Cover and the Cup, cut the
orange using a knife in order to remove it easily.
•
Oranges used must fit into the cups. If oranges are bigger or smaller for the size of the
Cups, the juice obtain may contain peel oil and bitter flavour.
•
When the machine is not to be operated, we recommend to switch it off (Fig. 6)
•
Use of bigger or smaller oranges to the recommended in this manual and lack of cleaning of
the Roller Track shall cause malfunctioning of the orange feeding system and breakages of
the Front Cover and Hopper Discharger-Tube. Those are not cover by the guarantee.
10
TROUBLESHOOTING
Problem
Cause and/or solution
The Programmer
display does not
work
Lack of electrical current.
Fuse burnt out. (Fig. 11-1)
Power cable improperly connected.
Turn on the power switch. Fig. 6
Humidity in electronic plate. Provide dry heat to the plate.
StoP appears on
the Programmer
display
Front Cover and / or Juice Tray not properly in place. (Figs. 8, 9 & 10)
Message “A”
blinking on the
Programmer
display
Check if you are using hard frozen oranges
Check if orange peels have piled up on the Juice Tray
Check if squeezing Balls are properly tightened
Check if orange peels are stuck inside the Cups.
In order to unblock the machine,
-
Switch off the machine
-
use an Allen key 5mm provided with the machine into the
machine right side hole (Fig. 20) and turn the Allen key
clockwise until the Cups are facing up vertically.
-
Remove the Allen Key before switching ON the machine.
Cups breaking
Fastening Nuts not properly tightened.
More washers than necessary under the squeezing Balls.
Squeezing Balls not properly tightened
The Blade is not properly positioned.
Oranges are either too small or too large for the size of squeezing Cups
used.
Blade breakage
The Blade has been misplace placed on top of the Blade shaft.
Squeezing Balls
breaking
Squeezing Balls not properly tightened.
Fastening Nuts not properly tightened.
More washers than necessary under the squeezing Balls.
Oranges are not
thoroughly
squeezed
Washers missing under the squeezing Balls.
Orange peels are too thin. Place extra washers under the squeezing
Balls ( maximum two washers)
Oranges do not fall
off the basket
Oranges used are too big.
The Hopper Plate is not properly tightened.
Cups do not stop at
the correct vertical
position
Correct the Cups stop position using the Programmer:
- Switch OFF the machine.
- Switch ON the machine pressing the ON bottom simultaneously. A
number of four digits will be shown on the Programmer display. The four
digits will remain on the display for only 3 seconds.
- Before the four digits disappear, press bottom ON.
- A number between 0 and 9 will be shown on the Programmer display.
This number represents 1/10 second delay of the moment when the
machine stops.
- If it is necessary to stop the machine before the time established,
select a smaller number.
5
