ZTW 4045201, Руководство пользователя

Страница: 8 / 12

7
Remark: One long tone “Beep-----”is equal to five short tones “Beep-”.
Tone of value
Prog.Item
BEEP-
BEEP-
BEEP-
BEEP-
BEEP-
BEEP-
BEEP-
BEEP-
BEEP-
BEEP-
BEEP
-----
BEEP
-----
BEEP-
BEEP
-----
BEEP-
BEEP-
BEEP
-----
BEEP-
BEEP-
BEEP-
BEEP
-----
BEEP-
BEEP-
BEEP-
BEEP-
Brake Type
Battery Type
Cut Off Voltage
Threshold
Restore Factory
Setup Defaults
Motor Timing
SBEC Voltage
Output
Governor Mode
Motor Rotation
Start Up Strength
Low Voltage Cut
Off Type
Brake
OFF
Soft
Brake
Mid
Brake
Hard
Brake
NiCd/
NiMH
LiPo LiFe
2.8V/50% 3.0V/60% 3.2V/60%
No
Protection
Restore
Auto 2˚ 8˚ 15˚ 22˚ 30˚
5.0V 6.0V 7.4V 8.4V
RPM OFF
st
1 Soft
Start
st
2 Soft
Start
Governor
Mode 1
Governor
Mode 2
Forward Reverse
10% 15% 20% 25% 30% 35% 40% 45% 50%
Reduce
Power
Cut Off
Power
FOR Example: Setting the motor timing ----15°
1). Switch your Transmitter ON and set the throttle stick to its maximum position.
Connect the battery pack to the ESC and wait for about 2 seconds until you hear two
sets of audible tone (
● ● ● ● ● ● ● ●
) confirming that the ESC has now entered the
programming mode.
2). After hearing “Beep-----”, put the throttle sticker to its minimum.
3). After hearing “Beep-Beep-Beep-Beep-” ,put the throttle sticker to its maximum,
the motor will emits special tones confirming the new setting has been stored.
4). Disconnect the battery pack.
Using Your New ESC
Improper polarity or short circuit will damage the ESC therefore it is your
responsibility to double check all plugs for proper polarity and first fit BEFORE
connecting the battery pack.