ZXV10 W300 (V5.2) Wireless ADSL Router Maintenance Manual
Default Settings
The factory default settings for a W300 router are listed as follows:
IP address: 192.168.1.1; subnet mask: 255.255.255.0.
Use the DHCP server by default (i.e., the IP address can be obtained from t
he W300 automatically via DHCP).
Line coding: Auto negotiation (T1.413/G.DMT/G.LITE/ADSL2 /ADSL2+).
Default network name (SSID) for WLAN, wireless encryption mode, and enc
ryption key are also marked on the label shown on the cover of the W300 r
outer.
Note:
If the W300 router fails to work due to error configuration or if the user forgets
the login password, insert a needle into the device’s
Reset
hole when the device is
running and hold
Reset
down for more than 10 seconds to restore the settings to the
default ones, then the system restarts automatically.
Computer Configuration
This section shows how to check computer configuration and configure TCP/I
P for a W300.
Checking Computer Configuration
If the computer uses a proxy server to access the Internet, it is suggested to
disable this proxy service before performing the configurations. It is recomm
ended to close the VPN software and the firewalls running on the computer.
For example, in Microsoft Internet Explorer, the user may check the proxy se
rvice configuration as follows:
10
Proprietary Information of ZTE CORPORATION
Содержание ZXV10 W300
Страница 66: ...Chapter 2 Product Installation This page is intentionally blank Proprietary Information of ZTE CORPORATION 55 ...
Страница 77: ...Proprietary Information of ZTE CORPORATION 66 ...
Страница 78: ...Chapter 2 Product Installation This page is intentionally blank Proprietary Information of ZTE CORPORATION 67 ...