3
2. Camera Mounting Spots
3. Adjust the camera
4. Wired connection
Adjust to the position you want up or down.
The neck of the stand attached to the mounting base, rotate the stand
by loosening the radial joint locking ring. Once in position ,tighten the
ring again.
Tips:
1. If you want the camera to work wirelessly, use Match Code to add camera to NVR. See the section 6 in this manual about
Add camera by matching code.
2. If you want the camera to work wired, use Auto Add. This requires you hard wire the cameras to router to get it work.
If some of the cameras' mounting spots are out of WiFi range, you need to hard wire the cameras to the NVR to get images.
1
2
1
2
2.1 Mount the cameras anywhere within the Wi-Fi range, plug them to power with included power adapters (smaller ones are
for cameras).
2.2 The cameras should start to stream videos to NVR within 1 minute.
2.3 If it does not display video on your monitor, the distance maybe too long or there are too many obstacles. Please move
the cameras closer to the NVR.
4.1 Use standard Network cables to connect the cameras to the Router
4.2 After connecting the camera to the router,please right click the mouse > go to "Video Manage" > click "Refresh" > click
"Auto Add" .Then you will see the camera is added to the NVR and display video on the screen.
Router
Network cables
Network cables
Camera
NVR
Step 1: Connect the NVR to the Internet
Connect the NVR’s WAN port to a LAN port of your router with an Ethernet cable. When the NVR is connected to the Internet,
within minutes you should see the Cloud ID and status shows "ONLINE" on the right bottom corner on your screen.(If the
Cloud ID is not displayed please go to System Setup and tick the Cloud ID icon)
Network Video Recorder
Network Video Recorder
Network Video Recorder
Network Video Recorder
Cloud ID:662023312 ONLINE
2. View on Smartphone
Tips:
If the status does not change to "ONLINE", please go to System Setup > Network Setup> enable the DHCP or manually
allocate an IP for the NVR. If it does not go ONLINE after these settings, please contact your network administrator for help.
(Ex.: port 80 may need to be opened on the router.)