Group 3 for notifications to Z-Wave devices associated in this group. Supported command
classes:
NOTIFICATION_REPORT
Group 4 for notifications to Z-Wave devices associated in this group. Supported command
classes:
SENSOR_BINARY_REPORT
Please refer to your controller's user guide for advanced programming instructions as they
are a little different for every software.
ADVANCED SETTINGS
If your controller’s software allows for advanced configuration and parameter adjustment,
you will be able to change and save the settings below and customize the Contact Sensor’s
performance to serve your needs.
Trigger Delay
Parameter 1: Set the delay time for turning associated devices OFF based on status change of
your Contact Sensor. The number entered as the value corresponds to the number of
seconds. So if 0 is entered by default, the Contact Sensor will report status change and trigger
an associated device to turn off instantly, without any delay. If you change this setting to 10,
the sensor will only trigger the associated device after 10 seconds the status change is
reported - if your door or window is closed, the light will not go off for another 10 seconds.
Values: 1 –
65536 (seconds). 0 (seconds) –
default setting.
Size: 2 byte dec.
Trigger Action
Parameter 2: You can choose if your Contact Sensor turns an associated device on or off when
sending the basic set command. Use value 0 to turn the associated device OFF and value 255
to turn it ON. Adjust brightness level for a Z-Wave dimmer (Multilevel switch) by putting in any
value between 1 and 99.
Values: 0 –
OFF; 1 –
99 (% of light); 255 – ON (default).
Size: 1 byte dec.
How to read the LED indicator?
Slow blink = Contact Sensor is powered on and NOT included to Z-Wave network
Fast blink = Contact Sensor is in inclusion mode
Fast flash = Contact Sensor is powered on and included to Z-Wave network
Single flash = Contact Sensor indicates status change (door opened or closed); sensor
indicates successful factory reset
MOUNTING
There are 2 ways to mount the Contact Sensor on your door or window frame:
1. Use the supplied screws to mount the sensor to door / window frame (recommended) and
the magnet to the moving part of your door / window.
OR
