5
6.
Attach the silencer to the body by
using screws.
Attach the air tube below the silencer.
7.
Attach the pump suction port part to the pump suction port,
and attach the air tube. (Like the picture on the right)
At that time, please be careful to avoid bending the air tube
towards the pump water inlet parts.
※If the water inlet part does not fit easily, please adjust
by using pump mount screw.
In order to prevent water leakage, remove the collection
cup, push it in firmly, and then rotate it.
8.
Install this machine in the filtration tank, please see
“Filtration Part” on the page 2.
Adjust the water level within the recommended
water level mark.
9.
In order to avoid running idle, fill the inside of the pump with water
Air Tube
The side with screw
holes is below
Pass the tube
through the hole
Attach with screws
Pump suction
port parts
Recommended water level width:
22cm-25cm
About the water level in the sump
Use this product within the recommended water level range.
If the water level is higher than the recommended water level width,
it may cause overflow.
Also, when the water level is lower, bubbles will not rise to the
collection cup.
Turn
Sideways
