Using the FIRE-36
13
ZOOM FIRE-36
shown on the display.
In program mode, the knobs and controls on the panel become inactive, and the settings of the
patch shown on the display are enabled.
2.
Use the [
Q
]/[
W
] keys to select the bank and number of the desired patch.
With the [
Q
]/[
W
] keys, you can cycle through the patches in the order U0 - U9
→
A0 - A9
→
b0 - b9
→
U0 ... (For information on factory default patch contents, see page 17.)
When you press the [PROGRAM/BANK] key, the patch number stays the same and only the bank
is toggled: U1
→
A1
→
b1
→
U1.
3.
Operate the controls in the input/preamp section and the effect section as required, to
adjust the distortion, tone, volume, effect type and intensity, etc.
It is also possible to modify a patch after it was loaded. When a knob or key was operated, a dot
appears at the bottom right of the display. This indicates that the contents of the patch have
changed. (When you return to the original settings, the dot disappears.)
H
INT
You can store the contents of a changed user patch by pressing the [STORE] key. For information on the
procedure, see the section "Storing a patch".
N
OTE
If you have changed some settings and then select another patch, the settings of the previous patch will
return to the stored condition. If you want to preserve your changes, store the user patch.
0
Patch number
Patch bank
U: User bank;
A, b: preset banks
4
Lit
4
FIRE36E.fm 13 ページ ２００４年６月２５日 金曜日 午前１１時１２分