Zoofari ZTSD 36 B1, Руководство по эксплуатации

Страница: 6 / 16

- 3 -
Operation
The fur to be cut must be dry and clean. Brush the
fur through to remove any knots.
t 3FNPWFUIFCMBEFHVBSE
7
from the cutting
head
.
t
Place the required trimming guide (
1
-
6
)
with the prongs facing upwards on the cutting
head
and thereby press the flap of the trim-
ming guide down firmly onto the lower metal
edge of the cutting head (see illustration).
t &OTVSFUIBUUIFUSJNNJOHHVJEFIBTQSPQFSMZ
engaged and is secured before starting to cut/
trim the fur.
Note:
It is advisable to first trim a small area so as to test
the individual comb attachments. Start with a comb
attachment for long hair (1/2“
4
or 3/8“
3
)
and, if necessary, use a shorter one. The comb
attachments permit cutting lengths from 3 to 13 mm.
t Switch the appliance on by sliding the On/Off
switch
UPUIFQPTJUJPOv0/i
t 4MPXMZSVOUIFBQQMJBODFUISPVHIUIFGVSBHBJOTU
the direction of hair growth. Hold the appliance
so that the trimming guide is as flat as possible
against the animal.
t In addition, with the adjustment switch the
cutting length of the cutter head can be
adjusted in steps(up to 2 mm) without having
to exchange the comb attachment. To do this,
slide the adjustment switch
backwards to
increase the cutting length in steps. With this the
cutting length of the respectively attached comb
attachment is also increased by up to 2 mm.
Slide the adjustment switch
forward again to
reduce the cutting length or to bring the comb
attachment back into its original position.
t
Through removal of the individual trimming
guide, i.e. using only the cutting head
itself,
you can cut clean contours.
t
After use, switch the appliance off by sliding the
On/Off switch
to the position „OFF“.
Cleaning and Care
Risk of electric shock!
Before cleaning, remove the plug from the mains
power socket.
/&7&3TVCNFSTFUIFBQQMJBODFJOXBUFSPSPUIFS
liquids.
t 5BLFUIFSFTQFDUJWFUSJNNJOHHVJEFJGmUUFEPé
t
Using exclusively the cleaning brush
8
, remove
the hairs from the cutting head
. The cutting
head may not be cleaned with water or
PUIFSMJRVJETFYDFQUNFEJDBMBMDPIPM
t If in regular use, the cutting head
should be
oiled occasionally. For this, use the supplied
blade oil
9 .
t 3FNPWFFYDFTTPJMXJUIBESZDMPUI
t $MFBOUIFIPVTJOHXJUIBTPGUESZMJOUGSFFDMPUI
t
Store the appliance in a dry and dust free
location. When it is in storage, place the blade
guard
7 on the cutting head .